Cut & Stick Replacement Mirror Glass - 7" x 10"

Installation Instructions
1. If lens is cracked and no pieces of glass are missing, proceed to instruction number 4 below after carefully cleaning existing cracked glass.
If pieces of glass are missing, please follow instructions 2 and 3 below, carefully.
2. Remove any left over pieces of glass by breaking away with small hammer or similar tool.
CAUTION: Wear safety glasses and gloves. Sharp glass may cause severe injury.
3. Remove any excess glue residue left behind from the old lens installation.
4. Lay the Cut & Stick mirror lens over your current mirror opening. Trace its outer shape on the Cut & Stick paper backing.
5. Cut along the traced line with a heavy scissors. Be careful to stay approximately 1/4" inside the traced line. This will allow for extra space taken up by the mirror housings outer trim and allow your lens to fit comforably inside the outer trim.
6. After double checking your fit ana dmaking necessary fit adjustments, place the foam tape pieces supplied on the back of your Cut & Stick lens. Remove the outer adhesive cover and stick your lens firmly in place inside mirror housing.
7. Remove the protective film from the mirror lens surface.

Cut & Stick is a temporary mirror repair solution. It does not have the perfect clarity of glass, however, it may be used as a temporary measure until a permanent glass lens can be reinstalled, which should be done as soon as possible. Please ask about new CIPA Custom Replacement Mirrors.